D1146/D1146TI/DE08TIS MAINTENANCE MANUAL z For the disassembling of valve seat, by welding the welding bead to a valve seat rotating tool or valve seat, pull it out with a special tool. M1072 z For the assembling of a new valve seat, by putting it among the dry ices of an ice box previously for about 2 hours for the cold shrinkage, and press it in the cylinder head by a special tool. (bench press) z Apply valve lapping compound to the valve head seating face on the valve seat and lap the valve seat by turning it until it is seated in position, then wipe out the lapping compound. 4) Valve spring z Visual check Check the appearance of valve spring and if necessary replace the spring.
z Valve spring free length Use a vernier caliper to measure the valve spring free length. If the measured value is less than the specified limit, the valve spring must be replaced. (mm) M1078 52 Printed in Jan. 2001 PS-MMA0415-E1A Spring free Length Standard Intake valve 64 mm Exhaust valve Inner D1146/TI : 60 DE08TIS : 73.8 Outer D1146/TI : 71 DE08TIS : 77.7