D1146/D1146TI/DE08TIS MAINTENANCE MANUAL z Valve spring inclination Use a surface plate and a square to measure the valve spring inclination. M1079 If the measured value exceeds the specified limit, the valve spring must be replaced. z Valve spring tension Use a spring tester to measure the M1080 valve spring tension if the measured value is less than the specified limit, the valve spring must be replaced. 5) Assembling cylinder head z Clean the cylinder head thoroughly. z Replace the valve stem seal with new one, and by means of a special tool, press the stem seal into the valve guide of cylinder head. z Coat engine oil to valve stem and valve guide and assemble the valve.
However, be careful for the damage of valve stem seal. 53 Printed in Jan. 2001 PS-MMA0415-E1A (unit : mm) Standard Limit Valve Spring Inclination Less than 1.8 mm 2.7 mm Set Length Spring force Limit Intake valve Valve Spring Tension at 41mm Set Length 70 kg ± 3% Exhaust valve Inner 38 mm D1146/TI : 28.6 kg ± 6 % DE08TIS : 38 kg ± 2kg Outer 41 mm D1146/TI : 66 kg ± 5 % DE08TIS : 75kg ± 4kg