D1146/D1146TI/DE08TIS MAINTENANCE MANUAL 2) Clearance Measure the clearance between the piston pin and connecting rod bushing, and replace either of them, whichever damaged more, if the measured value is beyond the limit. M1106 3) Condition check Check the engaged condition of the piston and piston pin. If it is possible to force the pin into the piston heated with piston heater, the piston is normal. When replacing the piston, be sure to replace the piston pin together. (5) Connecting rod inspection 1) Distorsion Check the connecting rod for distortion. As shown in the figure below, install the connecting rod to the connecting rod tester, and check for distortion using a feeler gauge.
If the connecting rod is found distorted, never re-use it but replace with a new one. 2) Holes alignment (parallelism) Measure the alignment of the connecting rod piston pin bushing holes with connecting rod big end holes. At this time also, use both connecting rod tester and feeler gauge. feeler gauge M1107 67 Printed in Jan. 2001 PS-MMA0415-E1A Standard Limit 0.003 ∼ 0.015 mm 0.08 mm Standard Limit 0.05 mm 0.1 mm or less