D1146/D1146TI/DE08TIS MAINTENANCE MANUAL torque. (30 kg.m). z Tighten the bearing cap in the sequence of . z Check to see that the assembled crankshaft turns smoothly with hand. 3.3.6. Flywheel housing z Temporarily install the guide bar on the cylinder block. z Apply gasket to the cylinder block. z Using the dowel pin and guide bar, install the flywheel housing and tighten the fixing bolts in a diagonal sequence to specified torque. (Zigzag method) Oil seal CAUTION : When the bolts are tightened, remove the guide bar. z The flywheel housing is assembled after the new oil seal was pressed (Coat engine oil over the outside of oil seal) before in the housing by a press.
z If any peripheral scar was generated due to oil seal at the oil seal contact surface of crankshaft, after inserting about 1 mm shim or thereabout in front of oil seal (Direction toward crankshaft.), measure and adjust. 3.3.7. Oil seal (Rear side) G1052 Torque 8 kg.m z Apply lubricating oil to the outside of the oil seal and flywheel housing inside diameter and fit them over the crank 73 Printed in Jan. 200 1 PS-MMA0415-E Oil Seal Fitting Jig 1 A