daewoo — Daewoo D1146 D1146TI DE08TIS Diesel Engine Maintenance Manual

D1146/D1146TI/DE08TIS MAINTENANCE MANUAL shaft, then assemble the oil seal using an oil seal fitting jig. 3.3.8. Flywheel z Installation of flywheel ring gear With a gas burner, heat the ring gear evenly until heat expansion takes place, then install it using a hammer. CAUTION : Do not allow the temperature of the ring gear to exceed 200 ° C (390 ° F). z By means of mandrel, assemble pilot bearing to the flywheel. z By means of mandrel, press in the wear ring at the backward face. z Install a guide bar into a bolt hole on the crank shaft, and lift the flywheel to align the dowel pin with the pin hole on the flywheel for temporary assembly operation.

z Coat the adhesive (#271 Loctite) over the assembling bolts and install bolts in the remaining holes. After that take out the guide bar, then install a bolt in the hole where the guide bar had been inserted. z According to the order of tightening tighten the fixing bolts using a torque wrench in a diagonal sequence to 74 Printed in Jan. 2001 PS-MMA0415-E1A M1122 M1122 wear ring ring gear G1031 G1031