D1146/D1146TI/DE08TIS MAINTENANCE MANUAL specified torque. 3.3.9. Magnetic pick-up sensor z Move the lock nut to hexagonal side of sensor completely. Lock nut z Rotate (Clockwise) the pick-up sensor on fly wheel housing, until the end of it reach on fly wheel ring gear. z Then rotate (Counter clockwise) the pick-up sensor for 270 ° (gap 1.0 mm) and fix lock nut. z Tolerance limit is 27 ° . (gap ± 0.1 mm) Flywheel housing Tolerance limit 3.3.10. Water chamber cover z Coat the adhesive over the water chamber cover (Particular around bolt holes) and after attaching the gasket, assemble it to the cylinder block using the bolts for assembling.
z As for tightening of bolts, after primarily tightening the bolts located at the both ends of cover (4ea at both sides) and middle bolts (Upper, lower 2ea) , tighten the rest. 3.3.11. Cylinder liner z Stand the cylinder block so that the flywheel faces downward. z Thoroughly clean the liner flange fitting surface and bore inside with 75 Printed in Jan. 2001 PS-MMA0415-E1A Torque 18 kg.m