D1146/D1146TI/DE08TIS MAINTENANCE MANUAL compressed air to prevent the entry of foreign substances. z After the cleaning operation, make the cylinder liner dried up and push it into the cylinder block by hand. z Wet the liner inside diameter with engine oil. 3.3.12. Piston and connecting rod z Use a piston heater to heat the piston approximately 100 ° C (212 ° F) for 5 minutes. M1127 z Align the piston pin hole with the oiled connecting rod small end and press the piston pin (by lightly tapping with a rubber hammer) to assemble the connecting rod with the piston.
z Nothing the direction of the piston, make the longer side(machined with Valve seating key groove on the bearing) of the connecting rod big end. z On the piston head surface, the side connecting rod big end is in opposite longer direction from the valve seating surface as well as in the same direction with the narrow margin of the combustion chamber. 76 Printed in Jan. 2001 PS-MMA0415-E1A