D1146/D1146TI/DE08TIS MAINTENANCE MANUAL Use care not to damage the cylinder liner and piston, and slightly lift and insert the piston into the cylinder so that the ring may not be damaged by the fillet of the liner. z Install the bearing in the connecting rod cap and apply oil. CAUTION : Make sure that the manufacture serial Serial no. numbers impressed on the connecting rod cap and connecting rod big end are identical, and install the connecting rod cap by aligning it with dowel pin. z Wet the fixing bolts with engine oil, semi-tighten them with hand, tighten them to the specified torque using a torque wrench as follows. (1) First stage : Coat engine oil over bolts. (2) Second stage :
Temporary bolt screwing about 1 2 threads (3) Third stage : With torque wrench, tighten up to about 10 kg.m (4) Fourth stage : With torque wrench, tighten up to about 15 kg.m (5) Fifth stage : By means of torque wrench, tighten finally in the specified torque. (18 kg.m). z When the connecting rod bearing cap bolts are tightened, check the connecting rod end play to the right and left with hand. If no end play is found,, 78 Printed in Jan. 2001 PS-MMA0415-E1A Torque 18 kg.m