daewoo — Daewoo D1146 D1146TI DE08TIS Diesel Engine Maintenance Manual

D1146/D1146TI/DE08TIS MAINTENANCE MANUAL remove and reinstall or replace the connecting rod bearing cap. 3.3.13. Timing gear case z Mount a new gasket using dowel pin on the cylinder block. z Put the time gear case to the cylinder block by aligning the dowel pin hole of timing gear case with its pin, and then assemble it by tapping lightly with an urethane hammer to the right and left (Particularly around dowel pin). z Tighten the bolts for assembling to the specified torque. However, in case of tightening the bolts, tighten primarily the bolts of both end parts and then do the rest. 3.3.14. Timing gear and idle gear pin z Install the oil pump idle gear onto the No.7 bearing cap.

z Install a thrust washer over the camshaft and assemble the cam gear by aligning Idle gear pin it with camshaft dowel pin. Tighten the cam gear assembling bolts to the specified torque. (Zigzag method) Torque 2.2 kg.m z With the oil port on the idle gear pin facing the cylinder block, install the idle gear pin. 79 Idle gear pin Oil hole Printed in Jan. 2001 PS-M MAG01401553-aE1 A