Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Replacing Valve Guide (When removing) 1. Press out the used valve guide using a valve guide replacing tool. (See page “SPECIAL TOOLS” .) (When installing) 1. Clean a new valve guide and valve guide bore, and apply engine oil to them. 2. Press in a new valve guide using a valve guide replacing tool. 3. Ream precisely the I.D. of the valve guide to the specified dimension. IMPORTANT Q Do not hit the valve guide with a hammer during replacement. (A) When Removing (B) When Installing W10278890 Valve Seating 1. Coat the valve face lightly with prussian blue and put the valve on its seat to check the contact. 2.

If the valve does not seat all the way around the valve seat or the valve contact is less than 70 %, correct the valve seating as follows. 3. If the valve contact does not comply with the reference value, replace the valve or correct the contact of valve seating. (1) Correct (2) Incorrect (3) Incorrect W10282190 S-47 KiSC issued 06, 2011 A Valve guide I.D. (Intake and exhaust) Factory spec. 7.010 to 7.025 mm 0.2760 to 0.2765 in. Valve seat width Factory spec. 2.12 mm 0.0835 in.