05-E2B, 05-E2BG, WSM DIESEL ENGINE Correcting Valve and Valve Seat NOTE Q Before correcting the valve and seat, check the valve stem and the I.D. of valve guide section, and repair them if necessary. After correcting the valve seat, be sure to check the valve recessing. 1) Correcting Valve 1. Correct the valve with a valve refacer. 2) Correcting Valve Seat 1. Slightly correct the seat surface with a 1.047 rad (60 °) (intake valve) or 0.785 rad (45 °) (exhaust valve) valve seat cutter. 2.
Resurface the seat surface with a 0.523 rad (30 °) valve seat cutter to intake valve seat and with a 0.262 rad (15 °) valve seat cutter to exhaust valve seat so that the width is close to specified valve seat width (2.12 mm, 0.0835 in.). 3. After resurfacing the seat, inspect for even valve seating, apply a thin film of compound between the valve face and valve seat, and fit them with valve lapping tool. 4. Check the valve seating with prussian blue. The valve seating surface should show good contact all the way around.
(1) Valve Seat Width (2) Identical Dimensions (A) Check Contact (B) Correct Seat Width (C) Check Contact (a) 0.262 rad (15 °) or 0.523 rad (30 °) (b) 0.785 rad (45 °) or 1.047 rad (60 °) (c) 0.523 rad (30 °) or 0.262 rad (15 °) W10283500 Valve Lapping 1. Apply compound evenly to the valve lapping surface. 2. Insert the valve into the valve guide. Lap the valve onto its seat with a valve flapper or screwdriver. 3. After lapping the valve, wash the compound away and apply oil, then repeat valve lapping with oil. 4. Apply prussian blue to the contact surface to check the seated rate. If it is less than 70 %, repeat valve lapping again.
IMPORTANT Q When valve lapping is performed, be sure to check the valve recessing and adjust the valve clearance after assembling the valve. W10288140 S-48 KiSC issued 06, 2011 A Valve face angle Factory spec. IN. 1.047 rad 60 ° EX. 0.785 rad 45 ° Valve seat angle Factory spec. IN. 1.047 rad 60 ° EX. 0.785 rad 45 °