05-E2B, 05-E2BG, WSM DIESEL ENGINE Free Length and Tilt of Valve Spring 1. Measure the free length (B) of valve spring with vernier calipers. If the measurement is less than the allowable limit, replace it. 2. Put the valve spring on a surface plate, place a square on the side of the valve spring. 3. Check to see if the entire side is in contact with the square. Rotate the valve spring and measure the maximum tilt (A) . If the measurement exceeds the allowable limit, replace it. 4. Check the entire surface of the valve spring for scratches. If there is any defect, replace it. W10289350 Valve Spring Setting Load 1.
Place the valve spring on a tester and compress it to the same length it is actually compressed in the engine. 2. Read the compression load on the gauge. 3. If the measurement is less than the allowable limit, replace it. (A) Tilt (B) Free Length W10784360 Oil Clearance between Rocker Arm and Rocker Arm Shaft 1. Measure the rocker arm shaft O.D. with an outside micrometer. 2. Measure the rocker arm I.D. with an inside micrometer, and then calculate the oil clearance. 3. If the oil clearance exceeds the allowable limit, replace the rocker arm and measure the oil clearance again. If it still exceeds the allowable limit, replace also the rocker arm shaft.
W10291500 S-49 KiSC issued 06, 2011 A Tilt (A) Allowable limit 1.0 mm 0.039 in. Free length (B) Factory spec. 37.0 to 37.5 mm 1.457 to 1.456 in. Allowable limit 36.5 mm 1.437 in. Setting load / Setting length Factory spec. 117.4 N / 31.0 mm 11.97 kgf / 31.0 mm 26.4 lbs / 1.22 in. Allowable limit 100.0 N / 31.0 mm 10.2 kgf / 31.0 mm 22.5 lbs / 1.22 in. Oil clearance between rocker arm and rocker arm shaft Factory spec. 0.016 to 0.045 mm 0.00063 to 0.00177 in. Allowable limit 0.10 mm 0.0039 in. Rocker arm shaft O.D. Factory spec. 11.973 to 11.984 mm 0.4714 to 0.4718 in. Rocker arm I.D. Factory spec. 12.000 to 12.018 mm 0.4724 to 0.4731 in.