Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE W10293660 (2) Timing Gears, Camshaft and Governor Gear Timing Gear Backlash 1. Set a dial indicator (lever type) with its tip on the gear tooth. 2. Move the gear to measure the backlash, holding its mating gear. 3. If the backlash exceeds the allowable limit, check the oil clearance of the shafts and the gear. 4. If the oil clearance is proper, replace the gear. W10280630 Governor Gear Backlash W1041576 Idle Gear 1 and 2 Side Clearance 1. Set a dial indicator with its tip on the idle gear. 2. Measure the side clearance by moving the idle gear to the front and rear. 3. If the measurement exceeds the allowable limit, replace the idle gear collar.

W10285590 S-51 KiSC issued 06, 2011 A Backlash between idle gear 1 and crank gear Factory spec. 0.032 to 0.115 mm 0.0013 to 0.0045 in. Allowable limit 0.15 mm 0.0059 in. Backlash between idle gear 1 and cam gear Factory spec. 0.036 to 0.114 mm 0.0014 to 0.0045 in. Allowable limit 0.15 mm 0.0059 in. Backlash between idle gear 1 and injection pump gear Factory spec. 0.034 to 0.116 mm 0.0013 to 0.0046 in. Allowable limit 0.15 mm 0.0059 in. (equipped with idle gear 2) Backlash between idle gear 1 and idle gear 2 Factory spec. 0.033 to 0.117 mm 0.0013 to 0.0046 in. Allowable limit 0.15 mm 0.0059 in. Backlash between injection pump gear and governor gear Factory spec.

0.030 to 0.117 mm 0.0012 to 0.0046 in. Allowable limit 0.15 mm 0.0059 in. (equipped with idle gear 2) idle gear 2 and governor gear Factory spec. 0.030 to 0.117 mm 0.0012 to 0.0046 in. Allowable limit 0.15 mm 0.0059 in. Idle gear 1 and 2 side clearance Factory spec. 0.20 to 0.51 mm 0.0079 to 0.0201 in. Allowable limit 0.8 mm 0.0315 in.