Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Camshaft Side Clearance 1. Set a dial indicator with its tip on the camshaft. 2. measure the side clearance by moving the cam gear to the front to rear. 3. If the measurement exceeds the allowable limit, replace the camshaft stopper. W10295630 Camshaft Alignment 1. Support the camshaft with V blocks on the surface plate at both end journals. 2. Set a dial indicator with its tip on the intermediate journal. 3. Measure the camshaft alignment. 4. If the measurement exceeds the allowable limit, replace the camshaft. W10296710 Cam Height 1. Measure the height of the cam at its highest point with an outside micrometer. 2.

If the measurement is less than the allowable limit, replace the camshaft. W10297880 S-52 KiSC issued 06, 2011 A Camshaft side clearance Factory spec. 0.07 to 0.22 mm 0.0028 to 0.0087 in. Allowable limit 0.30 mm 0.0118 in. Camshaft alignment Allowable limit 0.01 mm 0.0004 in. Cam height of intake Factory spec. 28.80 mm 1.1339 in. Allowable limit 28.75 mm 1.1319 in. Cam height of exhaust Factory spec. 29.00 mm 1.1417 in. Allowable limit 28.95 mm 1.1398 in.