Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Oil Clearance of Camshaft Journal 1. Measure the camshaft journal O.D. with an outside micrometer. 2. Measure the cylinder block bore I.D. for camshaft with a cylinder gauge, and calculate the oil clearance. 3. If the oil clearance exceeds the allowable limit, replace the camshaft. W10299330 Oil Clearance between Idle Gear 1 and 2 Shaft and Idle Gear Bushing 1. Measure the idle gear shaft O.D. with an outside micrometer. 2. Measure the idle gear bushing I.D. with an inside micrometer, and calculate the oil clearance. 3. If the oil clearance exceeds the allowable limit, replace the bushing.

If it still exceeds the allowable limit, replace the idle gear shaft. W10301050 Replacing Idle Gear Bushing (When removing) 1. Press out the used idle gear bushing using an idle gear bushing replacing tool. (See page “SPECIAL TOOLS” .) (When installing) 1. Clean a new idle gear bushing and idle gear bore, and apply engine oil to them. 2. Press in a new bushing using an idle gear bushing replacing tool, until it is flush with the end of the idle gear. (A) When Removing (B) When Installing W10302410 S-53 KiSC issued 06, 2011 A Oil clearance of camshaft journal Factory spec. 0.050 to 0.091 mm 0.00197 to 0.00358 in. Allowable limit 0.15 mm 0.0059 in. Camshaft journal O.D. Factory spec.

35.934 to 35.950 mm 1.4147 to 1.4153 in. Camshaft bearing I.D. (Cylinder block bore I.D.) Factory spec. 36.000 to 36.025 mm 1.4173 to 1.4183 in. Oil clearance between idle gear shaft (1 and 2) and idle gear bushing Factory spec. 0.020 to 0.054 mm 0.0008 to 0.0021 in. Allowable limit 0.10 mm 0.0039 in. Idle gear shaft 1 and 2 O.D. Factory spec. 25.967 to 25.980 mm 1.0223 to 1.0228 in. Idle gear bushing 1 and 2 I.D. Factory spec. 26.000 to 26.021 mm 1.0236 to 1.0244 in.