05-E2B, 05-E2BG, WSM DIESEL ENGINE (3) Piston and Connecting Rod Piston Pin Bore I.D. 1. Measure the piston pin bore I.D. in both the horizontal and vertical directions with a cylinder gauge. 2. If the measurement exceeds the allowable limit, replace the piston. Oil Clearance between Piston Pin and Small End Bushing 1. Measure the piston pin O.D. where it contacts the bushing with an outside micrometer. 2. Measure the small end bushing I.D. with an inside micrometer, and calculate the oil clearance. 3. If the oil clearance exceeds the allowable limit, replace the bushing. If it still exceeds the allowable limit, replace the piston pin.
W10304770 W10305740 Replacing Small End Bushing (When removing) 1. Press out the used bushing using a small end bushing replacing tool. (See page “SPECIAL TOOLS” .) (When installing) 1. Clean a new small end bushing and bore, and apply engine oil to them. 2. Using a small end bushing replacing tool, press in a new bushing (service parts) taking due care to see that the connecting rod oil hole matches the bushing hole. (1) Seam (2) Oil Hole (A) When Removing (B) When Installing (a) 0.785 rad (45 °) W10307120 S-54 KiSC issued 06, 2011 A Piston pin bore I.D. Factory spec. 22.000 to 22.013 mm 0.8661 to 0.8667 in. Allowable limit 22.03 mm 0.8673 in.
Oil clearance between piston pin and small end bushing Factory spec. 0.014 to 0.038 mm 0.00055 to 0.00150 in. Allowable limit 0.15 mm 0.0059 in. Piston pin O.D. Factory spec. 22.002 to 22.011 mm 0.8662 to 0.8666 in. Small end bushing I.D. Factory spec. 22.025 to 22.040 mm 0.8671 to 0.8677 in. Oil clearance between piston pin and small end bushing (Spare parts) Factory spec. 0.015 to 0.075 mm 0.00059 to 0.00295 in. Allowable limit 0.15 mm 0.0059 in. Small end bushing I.D. (Spare parts) Factory spec. 22.026 to 22.077 mm 0.86717 to 0.86917 in.