Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Connecting Rod Alignment NOTE Q Since the I.D. of the connecting rod small end bushing is the basis of this check, check bushing for wear beforehand. 1. Install the piston pin into the connecting rod. 2. Install the connecting rod on the connecting rod alignment tool. 3. Put a gauge over the piston pin, and move it against the face plate. 4. If the gauge does not fit squarely against the face plate, measure the space between the pin of the gauge and the face plate. 5. If the measurement exceeds the allowable limit, replace the connecting rod. W10314620 S-55 KiSC issued 06, 2011 A Connecting rod alignment Allowable limit 0.05 mm 0.0020 in.