Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE (4) Crankshaft Crankshaft Side Clearance 1. Set a dial indicator with its tip on the end of the crankshaft. 2. Measure the side clearance by moving the crankshaft to the front and rear. 3. If the measurement exceeds the allowable limit, replace the thrust bearings. 4. If the same size bearing is useless because of the crankshaft journal wear, replace it with an oversize one referring to the table and figure. (Reference) Oversize dimensions of crankshaft journal W10317070 Crankshaft Alignment 1. Support the crankshaft with V blocks on the surface plate at both end journals. 2. Set a dial indicator with its tip on the intermediate journal. 3.

Measure the crankshaft alignment. 4. If the measurement exceeds the allowable limit, replace the crankshaft. W10330010 S-58 KiSC issued 06, 2011 A Crankshaft side clearance Factory spec. 0.15 to 0.31 mm 0.0059 to 0.0122 in. Allowable limit 0.50 mm 0.0197 in. Oversize 0.2 mm 0.008 in. 0.4 mm 0.016 in. Dimension A 51.5 to 51.7 mm 2.028 to 2.035 in. 51.6 to 51.8 mm 2.031 to 2.039 in. Dimension B 28.20 to 28.25 mm 1.1102 to 1.1122 in. 28.40 to 28.45 mm 1.1181 to 1.1201 in. Dimension C 2.3 to 2.7 mm radius 0.091 to 0.106 in. radius 2.3 to 3.7 mm radius 0.091 to 0.106 in.

radius (0.8-S) The crankshaft journal must be fine-finished to higher than ∇∇∇∇ Crankshaft alignment Allowable limit 0.02 mm 0.0008 in.