05-E2B, 05-E2BG, WSM DIESEL ENGINE Commutator and Mica 1. Check the contact of the commutator for wear, and grind the commutator with emery paper if it is slightly worn. 2. Measure the commutator O.D. with an outside micrometer at several points. 3. If the minimum O.D. is less than the allowable limit, replace the armature. 4. If the difference of the O.D.'s exceeds the allowable limit, correct the commutator on a lathe to the factory specification. 5. Measure the mica undercut. 6. If the undercut is less than the allowable limit, correct it with a saw blade and chamfer the segment edges. (1) Segment (2) Depth of Mica (3) Mica (a) Correct (b) Incorrect W1155802 Brush Wear 1.
If the connect face of the brush is dirty or dusty, clean it with emery paper. 2. Measure the brush length (A) with vernier caliper. 3. If the length is than the allowable limit, replace the yoke assembly and brush holder. W1156360 S-66 KiSC issued 06, 2011 A Commutator O.D. Factory spec. Electromagnetic drive type 28.0 mm 1.102 in. Planetary gear reduction type 30.0 mm 1.181 in. Allowable limit Electromagnetic drive type 27.0 mm 1.063 in. Planetary gear reduction type 29.0 mm 1.142 in. Difference of O.D.’s Factory spec. Electromagnetic drive type Less than 0.05 mm 0.002 in. Planetary gear reduction type Less than 0.02 mm 0.0008 in. Allowable limit Electromagnetic drive type 0.4 mm 0.016 in.
Planetary gear reduction type 0.05 mm 0.0020 in. Mica under cut Factory spec. 0.50 to 0.80 mm 0.0197 to 0.0315 in. Allowable limit 0.20 mm 0.0079 in. Brush length A Factory spec. 16.0 mm 0.630 in. Allowable limit 10.5 mm 0.413 in.