Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Clearance between Outer Rotor and Pump Body 1. Measure the clearance between the outer rotor and the pump body with a feeler gauge. 2. If the clearance exceeds the factory specifications, replace the oil pump rotor assembly. W10356560 Clearance between Rotor and Cover 1. Put a strip of plastigage onto the rotor face with grease. 2. Install the cover and tighten the screws. 3. Remove the cover carefully, and measure the amount of the flattening with the scale and get the clearance. 4. If the clearance exceeds the factory specifications, replace the oil pump rotor assembly. (7) Starter W10357320 Overrunning Clutch 1.

Check the pinion and if worn or damage, replace the clutch assembly. 2. Check that the pinion turns freely and smoothly in the overrunning direction and does not slip in the cranking direction. 3. If the pinion slips or does not turn in both directions, replace the overrunning clutch assembly. NOTE Q Do not wash off the grease in the overrunning clutch with the chemicals or oils. [A] Electromagnetic Drive Type [B] Planetary Gear Reduction Type W1156799 S-65 KiSC issued 06, 2011 A Clearance between outer rotor and pump body Factory spec. 0.100 to 0.180 mm 0.0039 to 0.0071 in. Clearance between rotor and cover Factory spec. 0.025 to 0.075 mm 0.0010 to 0.0030 in.