05-E2B, 05-E2BG, WSM DIESEL ENGINE Correcting Cylinder 1. When the cylinder is worn beyond the allowable limit, bore and hone it to the specified dimension. 2. Replace the piston and piston rings with oversize ones. Oversize : 0.5 mm (0.0197 in.) NOTE Q When the oversize cylinder is worn beyond the allowable limit, replace the cylinder block with a new one. (1) Cylinder I.D. (Before Correction) (2) Cylinder I.D. (Oversize) W10344480 (6) Oil Pump Rotor Lobe Clearance 1. Measure the clearance between lobes of the inner rotor and the outer rotor with a feeler gauge. 2. If the clearance exceeds the factory specifications, replace the oil pump rotor assembly.
W10355630 S-64 KiSC issued 06, 2011 A Oversized cylinder liner I.D. Factory spec. D905-E2B / E2BG 72.500 to 72.519 mm 2.85433 to 2.85507 in. D1005-E2B / E2BG V1305-E2B / E2BG 76.500 to 76.519 mm 3.0118 to 3.0126 in. D1105-E2B / E2BG D1105-T-E2B V1505-E2B / E2BG V1505-T-E2B 78.500 to 78.519 mm 3.0906 to 3.0913 in. Allowable limit D905-E2B / E2BG 72.65 mm 2.8602 in. D1005-E2B / E2BG V1305-E2B / E2BG 76.65 mm 3.0177 in. D1105-E2B / E2BG D1105-T-E2B V1505-E2B / E2BG V1505-T-E2B 78.65 mm 3.0965 in. Finishing Hone to 1.2 to 2.0 mm μR max. ∇∇∇ (0.000047 to 0.000079 in. μR max.) Rotor lobe clearance Factory spec. 0.06 to 0.18 mm 0.0024 to 0.0071 in.