Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE (5) Cylinder Cylinder Wear 1. Measure the I.D. of the cylinder at the six positions (see figure) with a cylinder gauge to find the maximum and minimum I.D.’s. 2. Get the difference (Maximum wear) between the maximum and the minimum I.D.’s. 3. If the wear exceeds the allowable limit, bore and hone to the oversize dimension. (Refer to “Correcting Cylinder” .) 4. Visually check the cylinder wall for scratches. If deep scratches are found, the cylinder should be bored. (Refer to “Correcting Cylinder” .) (A) Top (B) Middle (C) Bottom (Skirt) (a) Right-angled to Piston Pin (b) Piston Pin Direction W10343890 S-63 KiSC issued 06, 2011 A Cylinder I.D. Factory spec.

D905-E2B / E2BG 72.000 to 72.019 mm 2.8346 to 2.8354 in. D1005-E2B / E2BG V1305-E2B / E2BG 76.000 to 76.019 mm 2.9921 to 2.9929 in. D1105-E2B / E2BG D1105-T-E2B V1505-E2B / E2BG V1505-T-E2B 78.000 to 78.019 mm 3.0709 to 3.0716 in. Allowable limit D905-E2B / E2BG 72.15 mm 2.8406 in. D1005-E2B / E2BG V1305-E2B / E2BG 76.15 mm 2.9980 in. D1105-E2B / E2BG D1105-T-E2B V1505-E2B / E2BG V1505-T-E2B 78.15 mm 3.0768 in.