05-E2B, 05-E2BG, WSM DIESEL ENGINE [2] GOVERNOR Q Three Lever Type Fork Lever (for General) The governor system is a mechanical governor that used the flyweight (5). The flyweight (5) is mounted on the governor shaft that rotates at the same speed as the crankshaft. Because the feature of this mechanism takes out the engine speed directly as a centrifugal force of weight, the speed control that the change in the engine rotational speed is sensitively transmitted to fork lever assembly (A) and accuracy is high is enabled. The fork lever assembly of this engine is composed of fork lever 1 (6), for lever 2 (9), and the floating lever (7). A slide plate is installed in fork lever 1.
The governor spring (3) is hooked to fork lever 2 (9). The floating lever (7) installs the torque pin (8) of the output drop prevention at the overload. The start spring (2) is hooked to a slide plate, and holds the control rack in the direction of the full fuel position. Fork lever 2 (9) and the floating lever are installed in fork lever 1 (6) with the fork lever shaft (4). The max torque limitation (1) device limits the amount of the fuel exhalation at the overload with the torque pin.
(1) Max Torque Limiter (2) Start Spring (3) Governor Spring (4) Fork Lever Shaft (5) Flyweight (6) Fork Lever 1 (7) Floating Lever (8) Torque Pin (9) Fork Lever 2 (A) Fork Lever Assembly W1012753 (At Rated Operation) When the engine is running, the fork lever 2 (9) and the floating lever (7) are moving with the fork lever 1 (6) due to the tension of the governor spring (3). During the time, the torque pin (8) is pressed into the floating lever by centrifugal force of the governor weight (5). The fork lever 2 (9) comes in contact with the fuel limitation bolt (10), and the fuel injection pump supplies a fuel necessary for rated operation.
(1) Max Torque Limiter (6) Fork Lever 1 (7) Floating Lever (9) Fork Lever 2 (10) Fuel Limitation Bolt W1012924 M-2 KiSC issued 06, 2011 A