05-E2B, 05-E2BG, WSM DIESEL ENGINE (2) Lubricating System Engine Oil Pressure 1. Remove the engine oil pressure switch, and set an oil pressure tester. 2. Start the engine. After warming up, measure the oil pressure of both idling and rated speeds. 3. If the oil pressure is less than the allowable limit, check the following. Engine oil insufficient Oil pump defective Oil strainer clogged Oil filter cartridge clogged Oil gallery clogged Excessive oil clearance Foreign matter in the relief valve (When reassembling) After checking the engine oil pressure, tighten the engine oil pressure switch to the specified torque. W10349520 (3) Cooling System Fan Belt Tension 1.
Measure the deflection (A) , depressing the belt halfway between the fan drive pulley and alternator pulley at specified force 98 N (10 kgf, 22 lbs). 2. If the measurement is not within the factory specifications, loosen the alternator mounting screws and relocate the alternator to adjust. (A) Deflection W10356670 S-17 KiSC issued 06, 2011 A Engine oil pressure At idle speed Factory spec. More than 49 kPa 0.5 kgf/cm2 7 psi At rated speed Factory spec. 196 to 441 kPa 2.0 to 4.5 kgf/cm2 28 to 64 psi Allowable limit 147 kPa 1.5 kgf/cm2 21 psi Tightening torque Oil pressure switch 14.7 to 19.6 N·m 1.5 to 2.0 kgf·m 10.8 to 14.5 ft-lbs Deflection (A) Factory spec. 7.0 to 9.0 mm 0.28 to 0.35 in.