Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Fan Belt Damage and Wear 1. Check the fan belt for damage. 2. If the fan belt is damaged, replace it. 3. Check if the fan belt is worn and sunk in the pulley groove. 4. If the fan belt is nearly worn out and deeply sunk in the pulley groove, replace it. (A) Good (B) Bad W1016443 CAUTION When removing the radiator cap, wait at least ten minutes after the engine has stopped and cooled down. Otherwise, hot water may gush out, scalding nearby people. Radiator Cap Air Leakage 1. Set a radiator tester (1) and an adaptor (2) on the radiator cap. 2.

Apply the specified pressure 88 kPa (0.9 kgf/cm 2 , 13 psi), and measure the time for the pressure to fall to 59 kPa (0.6 kgf/cm 2 , 9 psi). 3. If the measurement is less than the factory specification, replace the radiator cap. (1) Radiator Tester (2) Adaptor W1054156 Radiator Water Leakage 1. Pour a specified amount of water into the radiator. 2. Set a radiator tester (1) and an adaptor (2) and raise the water pressure to the specified pressure. 3. Check the radiator for water leaks. 4. For water leak from the pinhole, repair with the radiator cement. When water leak is excessive, replace the radiator.

(1) Radiator Tester (2) Adaptor W1016903 S-18 KiSC issued 06, 2011 A Pressure falling time Factory spec. More than 10 seconds for pressure fall from 88 to 59 kPa (from 0.9 to 0.6 kgf/cm2, from 13 to 9 psi) Radiator water leakage test pressure Factory spec. 137 kPa 1.4 kgf/cm2 20 psi