Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Motor Test CAUTION Secure the starter to prevent it from jumping up and down while testing the motor. 1. Disconnect the battery negative cable from the battery. 2. Disconnect the battery positive cable from the battery. 3. Disconnect the leads from the starter B terminal. 4. Remove the starter from the engine. 5. Connect a jumper lead from the starter C terminal (1) to the battery positive terminal (2). 6. Connect a jumper lead momentarily between the starter’s body and the battery negative terminal (3). 7. If the motor does not run, starter is failure. Repair or replace the starter. NOTE Q B terminal :

It is the terminal which connects the cable from the battery to the starter. C terminal : It is the terminal which connects the cable from the motor to the magnet switch. (1) C Terminal (2) Positive Terminal (3) Negative Terminal [A] Electromagnetic Drive Type [B] Planetary Gear Reduction Type W1019297 Magnetic Switch Test 1. Disconnect the battery negative cable from the battery. 2. Disconnect the battery positive cable from the battery. 3. Disconnect the leads from the starter B terminal. 4. Remove the starter from the engine. 5. Connect a jumper lead from the starter S terminal (1) to the battery positive terminal (2). 6.

Connect a jumper lead momentarily between the starter’s body and the battery negative terminal (3). 7. If the pinion gear does not pop out, the magnetic switch is failure. Repair or replace the starter. NOTE Q B terminal : It is the terminal which connects the cable from the battery to the starter. S terminal : It is the terminal which connects the cable from the starter switch to the magnet switch. (1) S Terminal (2) Positive Terminal (3) Negative Terminal [A] Electromagnetic Drive Type [B] Planetary Gear Reduction Type 0000010743E S-24 KiSC issued 06, 2011 A