Kubota — SERVICING

05-E2B, 05-E2BG, WSM DIESEL ENGINE Magnet Switch Continuity Test 1. Check the continuity across the C terminal (1) and the B terminal (2) with a circuit tester, pushing in the plunger. 2. If not continuous or if a certain value is indicated, replace the magnet switch. (1) C Terminal (2) B Terminal [A] Electromagnetic Drive Type [B] Planetary Gear Reduction Type 0000010771E Alternator on Unit Test (Before testing) Before alternator on unit test, check the battery terminal connections, circuit connection, fan belt tension, charging indicator lamp, fuses on the circuit, and abnormal noise from the alternator. Prepare full charged battery for the test.

NOTE Q Be careful not to touch the rotating engine parts while engine is running. Keep safety distance from the engine rotating parts. 1. Start the engine. 2. When the engine is operating measure the voltage between two battery terminals. If the voltage is between 13.8 V and 14.8 V, the alternator is operating normally. 3. If the results of alternator on unit test are not within the specifications, disassemble the alternator and check the each component part for finding out the failure. See the “DISASSEMBLING AND ASSEMBLING” and “SERVICING” for alternator. 0000010745E Glow Plug Lead Terminal Voltage 1.

Turn the key switch to the “ GLOW (or PREHEAT )” position, and measure the voltage with a circuit tester between the lead terminal and the engine body. 2. If the voltage differs from the battery voltage, the wiring harness or main switch is faulty. 0000010725E S-25 KiSC issued 06, 2011 A Regulating voltage at no load Factory spec. 13.8 to 14.8 V at 25 °C (77 °F) Voltage Main switch key at GLOW (or PREHEAT) Approx. battery voltage