05-E2B, 05-E2BG, WSM DIESEL ENGINE Glow Plug Continuity 1. Remove the glow plug. 2. Measure the resistance with a circuit tester between the glow plug terminal and the glow plug housing. 3. If the factory specification is not indicated, glow plug is faulty. 0000010726E Engine Stop Solenoid 1. Remove the engine stop solenoid from the engine. 2. Connect the jumper leads from the pulling coil P terminal to the switch (3), and from switch (3) to the battery positive terminal. 3. Connect the jumper leads from the holding coil H terminal to the switch (4), and from switch (4) to the battery positive terminal. 4.
Connect the jumper leads from the engine stop solenoid body to the battery negative terminal. 5. When switch (4) is turn on, the plunger pull into the solenoid body and then turn off the switch (4), the plunger comes out. 6. Turn on the switch (3) then turn on the switch (4), the plunger pull into the solenoid body and it keep in holding position after turn off the switch (4). 7. If the plunger is not attracted, the engine stop solenoid is faulty. IMPORTANT Q Never apply the current for pulling coil more than two seconds when inspecting. (1) Connector (2) Battery (3) Switch for Holding Coil (4) Switch for Pulling Coil P : Terminal for Pulling Coil H :
Terminal for Holding Coil W1020600 (6) Turbocharger Turbine Side 1. Check the exhaust port (3) and inlet port (5) side of turbine housing (1) to see if there is no exhaust gas leak. 2. If any gas leak is found, retighten the bolts and nuts or replace the gasket (2) / (4) / (6) with new one. (1) Turbine Housing (2) Gasket (3) Exhaust Port (4) Gasket (5) Inlet Port (6) Gasket W1076917 Compressor Side 1. Check the inlet hose (3) of the compressor cover (4) to see if there is no air leak. 2. If any air leak is found, change the clamp (2) and / or inlet hoses. 3. Check the intake hose (1) and the clamp to see if there is no loose or crack. 4.
If any loose or crack is found, tighten the clamp or change the hose to prevent dust from entry. (1) Intake Hose (2) Clamp (3) Inlet Hose (4) Compressor Cover W1077032 S-26 KiSC issued 06, 2011 A Resistance Factory spec. Approx. 0.9 Ω