05-E2B, 05-E2BG, WSM DIESEL ENGINE Boost Compensator (equipped with Turbocharger Model) Use the stop solenoid mounting bolt (3) for the dropout prevention of boost compensator (2) and the damage prevention of the guide (6) when detach the boost compensator. The guide (6) of boost compensator and the control rack (7) should be made the level when you install boost compensator assembly. 1. Disconnect the hose (4). 2. Remove the stop solenoid mounting bolt (M6 Ч 87 mm) (3). 3. Remove the stop solenoid (1). 4. Install the stop solenoid mounting bolt (3) in an original position again. 5. Remove the boost compensator mounting bolt (5). 6. Detach the boost compensator assembly (2). 7.
Remove the stop solenoid mounting bolt (3) with boost compensator assembly (2). (When reassembling) 1. Install the stop solenoid mounting bolt (3) in boost compensator assembly (2) and assemble it to the boost compensator installation position at the same time. 2. Tighten the boost compensator mounting bolt (5). 3. Remove the stop solenoid mounting bolt (3). 4. Install the stop solenoid (1) and tighten the mounting bolt (3). IMPORTANT Q NOTE Q Apply a liquid gasket (Three Bond 1217D or equivalent) to the boost compensator body.
(1) Stop Solenoid (2) Boost Compensator Assembly (3) Stop Solenoid Mounting Bolt (4) Hose (5) Boost Compensator Mounting Bolt (6) Guide (7) Control Rack W1031295 Speed Control Plate 1. Remove the engine stop solenoid (without turbocharger model). 2. Remove the speed control plate (1). (When reassembling) Apply a liquid gasket (Three Bond 1215 or equivalent) to both sides of the solenoid cover gasket and control plate gasket. Be careful not to drop the governor spring (2) into the crankcase. (1) Speed Control Plate (2) Governor Spring W1031942 S-34 KiSC issued 06, 2011 A