Kubota — Adjustment of Tracks

PURGING OF THE FUEL SYSTEM 1. Fill up the excavator with fuel. 2. Turn the starter key to the position "RUN". 3. The air in the fuel system will automatically be purged within one minute. After adjustment is completed: Using the socket wrench, tighten the grease nipple. Tightening torque must be between 98 to 108 N-m. A If the tracks are too tight, wear is increased. A If the tracks are too loose, the track pads may collide with the sprocket and wear is increased. The track may dislocate or come off. A Clean the track after every use.

A Should the track tension be high due to sticking mud, lift the track with the help of the boom, arm and bucket, idle the engine and remove mud from the track by rotating it. C Tension the tracks as specified: 1. Loosen the bolt and remove the cover. 2. Apply grease to the grease nipple. (1) Starter switch (A) "STOP" (B) "RUN" (C) "START" A If the purging was insufficient, the engine dies right after starting. In this case repeat steps 2 to 3 again. ADJUSTMENT OF TRACKS C To loosen the tracks, follow the following procedure: To avoid personal injury: A Do not loosen the grease nipple completely or too quickly. Otherwise grease under high pressure in the tension cylinder could squirt out.

A Do not crawl under the excavator. (1) Cover (2) Bolt (3) Grease nipple (4) Grease gun 3. Rubber Tracks Tension the track in the lifted position, so that the distance "A" (clearance between the track roller and the inside surface of the track) see illustration, in this case, if there is a seam mark " " on the inside surface of the track, the seam mark " " is positioned on the top center between the idler and the sprocket. 1. Loosen the bolts and remove the cover. 2. Using a socket wrench, loosen the grease nipple a few turns. 3. When grease oozes out from the thread, rotate the track and loosen the track in the lifted position (see illustration).

Steel Tracks To check the track tension, the track must be lifted from the ground as shown. The track tension is correct if the clearance between the outer end of the track roller and the track interior surface corresponds to the dimension specified in the table below. OTHER ADJUSTMENTS AND REPLACEMENTS 79 OTHER ADJUSTMENTS AND REPLACEMENTS " "