OTHER ADJUSTMENTS AND REPLACEMENTS 80 To avoid serious injury or death: A Do not work under the machine in this condition. A For your safety do not rely on hydraulically supported devices, they may leak down and suddenly drop or be accidentally lowered. To avoid personal injury or death: A When lifting the machine itself with an attachment, place a safety block or safety post to prevent the machine from turning over. Keep the lock lever for attachment control in the "LOCK" position. (1) Drive sprocket (2) Idler A Make sure that no obstacles, such as stones are caught in the track. Remove such obstacles before adjusting the track tension.
A Track seam The ends of the rubber track are joined with a seam. When adjusting the tracks, the seam must be positioned on the top midway between the idler and the sprocket. If the seam is positioned incorrectly, the tracks will be tensioned too loosely, and a further readjustment will be necessary. A Rotate the track after adjustment one to two times to check the tension. A Additionally following points are to be observed when adjusting rubber tracks. (1) If the track loosen more than 50 mm, readjust them. (2) Check track tension 50 hours after initial use and readjust if necessary. Check and adjust thereafter every 50 service hours. B Special Information when Using Rubber Tracks 1.
When turning, make a slow swing turn. Avoid spin turns to reduce lug wear and entry of dirt. 2. The relief valve may be activated if too much dirt and sand clog the tracks. In this case move the machine for a short distance straight backwards to let the earth and sand fall off, then a turn can be made. 3. Avoid using rubber track on riverbeds, stony underground, ferro-concrete and on iron plates. The rubber can damage as well as increase wear on the tracks. (1) Seam (Mark " ") (A) 80 to 85 mm (A) 10 to 15 mm