17 CHECKS BEFORE START B When the Check-up is Completed When the check-up is completed, perform the following procedure to make the Periodic Check disappear from the screen. 1. The message below appears onscreen to prompt the completion of the check-up. 2. To take a look at the check points, press the information switch. The check points appear onscreen. 3. When the check-up has been completed, press the switch 5. If not, press the switch 1 to go back to the previous screen. B Working Light Switch When the starter switch is in position "RUN", the light(s) will be switched on by pressing the switch. (1) Working light switch C Night operation To avoid personal injury:
A When the working light and CAB light alone do not provide sufficient visibility, prepare additional stationary artificial lighting and observe safety rules for night work. (1) Switch 4 (2) Switch 1 (3) Switch 5 B Horn Switch B AUX Port Flow Rate Limit Switch It is possible to freely readjust the actuator's maximum flow rate in the AUX operating mode. (See "AUX PORT OPERATION" section for detail.) (1) Horn switch (1) AUX port flow rate limit switch