Kubota — Draining Water Separator

63 REGULAR CHECKS AND MAINTENANCE WORK REGULAR CHECKS AND MAINTENANCE WORK B Draining Water Separator [Checking and Draining] Water and dirt contained in fuel will settle down in the water separator. When such foreign substances are deposited, set the water separator handle to the "CLOSE" position. Loosen the top screw first and then the bottom cock to let the foreign substances out of the separator. Finally be sure to air-bleed the fuel system. To avoid personal injury: A When operating, keep hands and body inside of the ROPS / FOPS protective envelope. A Do not touch the control levers and the pedals from outside the cab during the engine running.

EVERY 50 SERVICE HOURS B Draining the Water from the Fuel Tank [Cleaning] 1. Set the water separator handle to the "CLOSE" position. 2. Loosen and remove the cup proper, and clean its inside with light oil. 3. Tighten up the cup proper. To avoid personal injury: A Before draining the water from the fuel tank, be sure to stop the engine and remove the key. A Do not smoke during inspection. 1. Open the cover. 2. Open the drain cock. (1) Screw (2) Cup (3) Water separator handle (4) Line (5) Float (6) Cock (A) Close (B) Loosen (C) Tighten (1) Cover (2) Drain cock (A) Open (B) Close A As water is collected, the red float goes up.

When the float has reached the specified line, immediately drain the water separator. A In reattaching the water separator, be careful to keep off dust and dirt. A Be sure to purge the fuel system before getting the machine restarted. (See "PURGING OF THE FUEL SYSTEM" in "OTHER CHECKS AND REPLACEMENTS" section.)