Kubota — Drive Unit Oil Change (First Oil Change of the 50 Hours)

71 REGULAR CHECKS AND MAINTENANCE WORK 4. Let the engine idle for approx. 5 min. Check the engine oil level. To check the engine oil level, insert the engine oil dipstick completely into the respective port opening and pull out again. If the oil level lies between both markings, no oil must be added. EVERY 500 SERVICE HOURS Do all 50, 100 and 250 hour servicing at the same time. B Drive unit Oil Change(First Oil Change of the 50 hours) A Regardless of the service hours, an engine oil change is due every 1 year. Engine oil volumes (with engine oil filter) 9.0 L To avoid personal injury:

A Lower all attachments to the ground, stop the engine and remove the key before undertaking the oil change. B Replacing Engine Oil Filter 1. Replace the oil filter cartridge at the same time as doing the engine oil change. 2. Remove the cartridge with the supplied filter wrench. 1. Rotate the track so that the drain plug of the drive unit is in the bottom position. 2. Remove the drain plug to let the oil run out. Screw in and tighten the drain plug again and fill with gear oil through the oil check port. 3. Fill oil until it overflows out of the oil check port. Oil change - first oil change after 50 hrs - then every 500 hrs - or at least once a year 4. Use prescribed gear oil SAE 90.

(1) Oil filter 3. Oil the O-ring of the new oil filter cartridge lightly. Then tighten the oil filter cartridge by hand. 4. Fill engine oil to the specified level. 5. Let the engine run for approx. 5 min. and make sure that the engine oil indicator lamp does not light up. Then stop the engine and remove the key. 6. The engine oil level is reduced by the amount of the filter capacity after the engine is started. It is usually necessary to add oil. (1) Oil check port (2) Drain plug (3) Oil filling port A Always check the oil level after having exchanged the filter. Gear oil volume approx. 0.9 L