Kubota — Replacing the Hydraulic Pilot Filter Element

REGULAR CHECKS AND MAINTENANCE WORK 72 B Replacing Fuel Filter Cartridge EVERY 1000 SERVICE HOURS Do all 50, 100, 200, 250 and 500 hour servicing at the same time. To avoid personal injury: A Keep fire away. B Replacing the Hydraulic Pilot Filter Element 1. Remove the filter with the filter wrench. 2. Apply a light film of fuel to the seal of the new filter and turn in tightly by hand. 3. Open the cock of the fuel filter again. To avoid personal injury: A Before replacing the element, wait long enough for the hydraulic fluid to cool down. 1. Open the side cover. 2. Remove the pilot filter case from the head cover. 3. Wrench and pull out the element downward. 4.

Replace the O-ring with a new one. 5. Apply a light coating of clean hydraulic oil to the O-ring and fit it to the case firmly. Be careful not to scratch the O-ring. 6. Attach the case to the head cover firmly. 7. Let the engine run for approx. 3 minutes. 8. Check the oil level of hydraulic oil tank, then tighten the oil filling plug. (1) Fuel filter cartridge A After exchange of the filter, the fuel system must be purged of air. B Replacing Breather Filter See "Replacing Hydraulic Return Filter Element" in "EVERY 1000 SERVICE HOURS" section. (1) Rear right cover