Komatsu — STARTING ENGINE

. OPERATION OPERATION (50 to -22 F) Engine Cooling Water Auto Warming-up Function This is a function to automatically warm up engine cooling water more quickly by raising an engine idling speed. When the turbocharger protection function and engine cooling water auto warming-up function are activated at the same time, the former takes priority over the latter. During the warming-up operation,even if the fuel control dial is set to a position below 1200 rpm, the engine speed is held at 1200 rpm. This function continues to work for a maximum of 10 minutes, or until the engine cooling water temperature reaches 30 ° C (86 ° F).

If the decelerator pedal is depressed during the automatic warming-up operation, the automatic warming-up function is cancelled and the engine speed drops to below 1200 revolutions per minute. In addition, the automatic warming-up function is also cancelled by the following procedure. 1) Turn the fuel control dial to the full speed position (MAX) and hold it there for 3 seconds. 2) If the fuel control dial is turned to the low idling position (MIN), the engine speed will go down. 3 - 88 Turbo p rotect functio The tur bo protect f unction is a function to protect the turbocharger by keeping the en gine speed at less than 1000 rpm im mediately af ter the engine is started.

Whe n the turbo p rotect f unction is actuated, the engine speed is h eld at less than 10 00 rpm, eve n if the fuel c ontro dial i s operated. Whe n the turbo p rotect f unction is canceled, th e engine speed is set to the speed for the positio n of the fuel c ontro dial. The relationship he he turb o protect function an d th e temperature of t he engin e coolant is as shown in th e table. Duri ng operation of the t urbo protect function, t he machine does not a ccep t any o peratio n to move the machin