. OPERATION OPERATION OPERATION OPERATION (3) pilot 7. After the engine starts, release the key in the starting switch. The key will automatically return to the ON position. REMARK Immediately after an engine startup, keep the engine idling, and while the engine is idling, keep the foot off the deceleration pedal and do not operate the work equipment. 8. When the engine rotation stabilizes, return to the low idle (MIN) position of fuel control dial (1) and then carry out the warming-up operation.
REMARK Regardless of the coolant temperature, if the key in the starting switch is turned from the OFF position to the left, the preheating pilot lamp will light up and preheating will be carried out. (Preheating continues while the key in the starting switch is kept turned to the left.) For details of the preheating time, see the chart for Step 6. If the engine does not start when the above operation is carried out, wait for at least 2 minutes, then repeat the procedure in Steps 3 and 4. 3 - 87 4. Chec panel lights up. 5. Maintain the key in the lamp (3) goe s off. pilot lamp on the monitor on position until the pre-heatin 6.
When preheating pilot lamp (3) goes out, turn the key in starting switch (2) to the STA RT position and st art the engine. The length time pilot (3) oolant temperature. Coolant temperature (°C (°F)) Lighting-up time (sec) -5 - -15 (23 - 5) 5 - 30 below -15 (5) 30