Komatsu — TIPS FOR LONGER UNDERCARRIAGE LIFE

. OPERATION OPERATION 3 - 111 TIPS FOR LONGER UNDE Undercarriage life greatly varies depending on operation method, inspection and ma operation, keep the following poi OPERATION METHOD suits the type of soil to be encountered in service. distributor when selecting track shoes. ccur during operation. load on the blade until slipping stops. ion or stops, unnecessary high speeds and sharp turns. straight line whenever possible.

When making turns, be careful not to allow the Select the track shoe that best Please consult your Komatsu distributor when selecting track s Do not allow shoe slipping to o If shoe slipping occurs, reduce load on the blade until slipping Avoid sudden starts, accelerat ion or stops, unnecessary high s peeds and sharp t Always operate machine in a straight line whenever possible. When making turn machine to stay to one side, s o operation in both turning directions can be done properly. Make turns with the rs and obstacles to prevent machine from riding over them while operating. ne parallel to the inclination of the he slope.

Also when stopping the hine should face the top of the e left or right during digging o dig with the incline. Move the and start to dig again. that are difficult to move during rations, and the idler or sprocket t means that the operation is avoid such operations. turns w ith the largest possible radius. Prior to operation, clear boulde rs and obstacles to prevent machine from riding ov er them while o peratin On a slope, operate the machi ne parallel to the inclination of the slope. Do not operate across t he slope. Also when stopping the machine on a slope, the mac slope.

When ground inclines to th operations, do not continue t hine should face the top of the e left or right during digging o dig with the incline. Move the machine back to level ground If you come across obstacles and start to dig again. that are difficult to move during dozing operations or ripper ope rations, and the idler or sprocket come up from the ground, i excessive for the machine, so INSPECTION AND ADJUSTM ENT oper tension. Adjust the track shoe to the pr When adjusting the tension, m easure clearance A between the idler and carrier roller in the d iagram on the right.

The normal 1.2 in), but on bedrock, set the clearance is 20 - 30 mm (0.8 - tension slightly higher, and on clay ground, set it slightly looser. If the track is excessively loose , it may cause abnormal vibration during the operation and abno (For details of the method of ins rmal wear of the sprocket teeth. pection and maintenance for the track tension, see "CHECK TR ACK SHOE TENSION, ADJUST (PAGE 4-29)".) Check for oil leakage from th e idlers and sprockets, and for loose bolts or nuts. If any probl em is found, repair it immediately. Check clearance S between the idler guide plate and track frame.

If clearance S becomes larger, the idler will move to the side and cause the track assem bly to come off. For details of the method of inspection and mai ntenance, see "ADJUST IDLER CLEARANCE (PAGE 4-43)".