. MAINTENANCE GUIDE TO MAINTENANCE CHECK SERVICE METER: Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. KOMATSU GENUINE OILS: For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature. 4 - 2 GUIDE TO M Do not perform any i nspection and maintenance oper ation tha t is not foun KOMATSU GENUINE REPLACEMENT PARTS: Use Komatsu genuin e parts specified in the Parts Bo ok as replacement p ALWAYS USE CLEAN WASHER FLUID: Use automobile wind ow washer fluid, and be careful not to let any dirt get CLEAN OIL AND GRE ASE:
Use clean oil and gre ase. Also, keep the containers o f the oil a nd grease c lean. Keep foreign materials a way from oil and grease. CHECKING FOREIGN MATERIALS IN DRAINED OIL: After oil is changed or filters are replaced, check the old oil and fi lters for met al particles and for eign material s. If l arge quantity of metal par suitable action. ticles or foreign materials are found, always report to the person in charge, and carry out harge, carry FUEL STRAINER: Do not remove the st rainer from the filler port when a dding fue WELDING INSTRUCT IONS: Cut off power. Wai t for approx.
one minute after tur ning off t he engine starting switch key , and then di sconnect the negative (-) ter minal of the battery. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. re is no seal or bearing between the welding point and the grounding point. damage to the seals. a around the work equipment pins or the hydraulic cylinders as the grounding point. Do not apply more Connect groundin g cable within 1 m (3.3 instruments, conn ectors, etc., the instruments may malfunction.
Be careful that the re is no seal or bearing between the welding point an d the grounding p Sparks will cause Do not use the are a around the work equipment pi ns or the hydraulic c ylinders as the gro unding point DO NOT DROP THING S INSIDE MACHINE: When opening ins pection windows or the oil filler p ort of the tank to car ry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are d lead to failure. If y s inside the machine. ropped inside the machine, it ma y cause damage an d/or malfunction of the machine , an d will ou drop anything inside the mac hine, always remove it immediately. r inspection. Do not put unnece ssary things in your pockets.
Ca rry only things whic h are necessary fo r inspection.