. MAINTENANCE GUIDE TO MAINTENANCE DUSTY WORKSITES: into the oil. 4 - 3 When working at dusty worksites, do as follo Clean the radiator core frequently to avoid Clean and replace the fuel filter frequently. Clean electrical components, especially th e starting motor and alternator, to avoid accumulatio n of du When inspecting or changing the oil, move the machine to a place that is free of dust to prevent dirt fro m getting AVOID MIXING OILS: If a different brand or grade of oil has to be add ed, drain the old oil and replace all the oil with the new brand or grade of oil. Never mix different brand or grade of oi l.
PRECAUTIONS WHEN OPENING OR CLOSING REAR MASK Stop the engine and fan before opening or closing the rear mask. If you touch the fan when it is rotatin g, it may cause serious personal injury. careful not to get your fingers caught by the tank. When opening or closing the rear mask, be After opening the rear mask, check that the lock is applied securely. Check also that there is no a bnormality with the lock or link portion. t to hit your head on the rear mask. mage in the hoses or piping that move together with the rear mask. After opening the rear mask, be careful no Check that there are no cracks or other da mage in the hoses or piping that move together with the rea r mask.
PRECAUTIONS WHEN OPENING INSPECTION COVER Do not move the blade when the front cover and engine side cover on the left side of the machin e are o pen. The blade will hit the covers and there is danger t hat the covers may be broken. LOCKING THE INSPECTION COVER: Lock inspection cover securely into position with the lock bar. If inspection or maintenance is performed with with inspection cover not locked in position, there is a danger that it may be suddenly blow shut by the wind a nd cause injury to the worker. HYDRAULIC SYSTEM-AIR BLEEDING: After repairing or replacing hydraulic equipme nt or after removing the hydraulic piping, it is necessary to bleed the air from the circuit.
For details, see "PROCED URE FOR BLEEDING AIR IN HYDRAULIC SYSTEM (PAG E 4-45)". PRECAUTIONS WHEN INSTALLING HYDRAUL IC HOSES: here are O-rings or gasket seals, clean the mounting surface, and assemble the O-rings and gaskets. When removing parts at locations where t replace with new parts. When doing this, be careful not to forget to When installing the hoses, do not twist the m or bend them sharply. If they are installed so, thei r servic e life will be shortened extremely and they may be d amaged. ace, and