Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE ADJUST PLAY IN CENTER BALL WARNING Adjust as follows. whole and move (1) and 58kgm, 4 - 44 When adjusting, always se t the work equipment lock lever to the LOCK position except when operati ng the blad It is necessary to adjus t the shim at the center ball portion in the following cas When there is play i When the blade is re assembled after having been rem oved for transportati on of the m If the adjustment is not made, the play will become larger. S and and soil will ent er the ball p ortion and t his will cause premature wear and da Adjust with shims so th at the play at the center ball is 0.2 - (0.008 - 0.047 in). d loosen bolt (2). 1.

Remove bolt (1) an 2. Remove all shims ( so that dimensio circumference. 3. Measure clearance of (A) + (0.2 -1.2 m 4. Select a shim thickn several shims), th temporarily tighten 5. Angle and tilt the bl If the blade move sound, the adjus If there is a squ smoothly, add s If the play at the 6. If the work equipm (2). Tightening torque 336.3-419.5lbft) 1. Remove bolt (1) an 2. Remove all shims ( 3) and temporarily tighten bolts (1) n (A) is uniform around the (A) and decide a shim thickness of m (0.008 - 0.047 in)). 4. Select a shim thickn ess that will give the set thickness ( en return to the original positi bolts (1) and (2). ade. 5.

Angle and tilt the bl s smoothly without making any sq tment is complete. eaking sound or the blade does no hims. ball is still excessive, remove more ent moves smoothly, tighten bolts : 456 - 569Nm (46.5 - Standard shim thicknes Shim thickness: 1.0 mm (0.04 in) (x 2), 2.0 mm (0.08 in) (