. MAINTENANCE SERVICE PROCEDURE 3. Bleeding air from cylinders air completely. wait for at least 5 minutes before starting 4 - 45 PROCEDURE FOR BLEEDING AIR IN HYDRAULIC SYSTEM After replacing or cleaning the hydraulic oil, filter element, or straine r, bleed the air from t See "STARTING ENGINE (PA GE 3-84)". ed and the blade must be operated, see OPERATION. Since the engine must be start ed and the blade must be operated, 1. Bleeding air from pump 1) Remove the cap of oil tank. 2) Remove the floor mat a 3) Loosen air bleeder (1) i that oil oozes out. 4) After completion of the air bleed plug. Tightening torque:
11.8 lbft)} 5) Close the hydraulic tan filler (F) at the top of the hydraulic nd floor plate. nstalled to the drain port and check air bleeding operation, tighten the - 14.7 Nm {1.2 - 1.5 kgm (8.7 - 10.8 k cap. NOTICE If the inside of the pump case is not filled with hydraulic oil and the pump is operated, there is dange this will cause premature damag r that it willgenerate abnormal heat and e to the pump. 2. Starting engine Start the engine and run fo After running for 10 minute r 10 minutes at low idle. For details, see "STARTING EN s at low idle, move to the next operation. dle, and extend and retract each cylinder 4 to 5 times, tak ing care that a cylinder is f its stroke.
(Stop the cylinder approx . 100 mm (3.9 in) sh ort of its stroke end) nder 3 to 4 times to the end of its stroke. high idling and operate each cylinder 4 to 5 times to the en d of its stroke to bleed the NOTICE If the engine is run at high speed im mediately after startup or a cylinder is pushed up to its stroke end , air taken inside the cylinder may cause damage to the piston p acking. 4. Operation 1) After completing the bl operations. This will rel 2) Check that there is no ease the bubbles in the oil inside the oil leakage, and wipe off any oil that