. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 4 - 54 2. Remove clamp (6), ins ert a bar between alternator (7 ) and th cylinder block, and use it to hold alternat or (7) i n position. To prevent damage to alternator (7) when holdin g it in position insert a wooden block between the bar a nd alternato r (7). 3. Loosen bolts (8) and ( 4. Use t he bar to move al ternator (7) and ad just th e bel t tension 5. Tighten bolts (8) and ( 9) to hold alternato 7. Instal 8. Instal REMARK Check each pulley for b reakage and wear of the V-groove. In p articular, c heck that the V-b elt does not touch the bottom of the V-groove.
nd, please contact your Komatsu distributor for replacement of the pulley. nd there is no allowance for adjustment, or if it is cut or cracked, please contact your replacement. If any abnormality is fou nd, please contac t your Komatsu distributo r for r eplacement of th If the bel t is stretched a nd there is no wanc Komatsu distributor for When adjusting the V-b elt, do not press th e alternato r directly with a bar, but put a wood p iece, etc. in-between them. If the V -belt has been re placed with a new part, t here will be initial el ongation, so inspect an d adjust it again after one-hour of operation.