Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REMARK at the top of the fuel same procedure to 4 - 63 14. After re placing filter cart ridge (5), bleed the air fr om the fu el circuit as follows 15. Fill the fuel tank with fu el (to the position where t he float is at the highest pos 16. Loosen the knob of fee and ou t until it becomes I t is not pre-filte r and fuel main fi After th e engine runs ou operate feed pump (6) a nd bleed the air. 17. After fi nishing the air ble eding, push in t he knob of feed pu (6) and tighten it. 18.

After re placing the filter cartridge, start t he engin e and run it for 10 minutes a Check that there is no l eakage of fuel fr om the fil ter seal s urface and the tra nsparent cap moun ting surface. I any lea kage of fuel is fou nd, check that th e filter ca rtridge is tightened properly . If the fuel still leak s, repeat Step 1 - 7 to remove the filter cartridge, then c heck the packing s urface for damage or embedded dirt. If any problem is foun d, replace the ca rtridge with a ne w part, th en repea t Steps 8 - 17 to in stall the new cartri 19. Close t he inspection co