Komatsu — EVERY 500 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE the water and sediment from left with a filter wrench. (This the bottom of the new filter thinly with oil, then 4 - 62 3. Remove the front cover at the 4. Pull out drain hose (2) to the f 5. in a container to catch the dra Loosen drain valve (3), drain inside transparent cap (4), the in filter cartridge (5). 6. Turn transparent cap (4) to th cap is to be used again, so re any damage on it.) 7. Using a filter wrench, turn cart 8. Install transparent cap (4) t cartridge. (When doing this, a 9. When installing, coat the O-rin g thinly with clean fuel, bring it into contact with the seal s (5), then tighten a further 1/4 - 1/2 turns.

If the transparent cap is tighte ned too much, the O-ring will be damaged and this will c it is not tightened enough, ther e will be a gap at the O-ring and this will also cause leakag problem, always tighten to the proper tightening angle. new filter cartridge with clean fuel, coat the packing surfa 10. Clean the filter holder, fill the install to the filter holder. NOTICE When adding fuel, do not remove small holes (A) on the dirty side. After adding fuel, remove cap (B) a Always fill with clean fuel. Be caref the fuel. In particular, center portio cap (B) when adding fuel. Be carefu portion on the clean side. 11.

When installing, tighten until th e packing surface contacts the seal surface of the filter ho of a turn. If the filter cartridge is tightene d too far, the packing will be damaged and this will lead t filter cartridge is too loose, fue l will also leak from the packing, so always tighten the co When tightening with a filte r wrench, be extremely careful not to dent or damage the 12. Check that the drain valve (3) is tightened securely. 13. Open fuel supply valve (1).