Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL TANK BREATHER ELEMENT NOTICE 4 - 67 13. After replacing the filter cartridge, st art the engin e and run it fo r 10 minutes at low idlin k that there is no leakage of fu el fro m the fil ter seal s urface a nd the transparent c ap mounting surfac akage of fuel i s found , check th at the filter ca rtridge is tightene d properly. If the fuel still leaks, repeat St o remove the filter cartridge, th en check the packing s urface fo r damage or embe dded dirt. If any prob nd, replace th e cartridge with a new part, th en repea t Steps 6 - 12 to install the n 14. Close the inspectio n cover.

Note that t he fuel tank bre ather an d hydrauli c tank breather have different part (The eleme nt is common t o both. F or d etails, see " WEAR P ARTS LIST (PAGE 4- Fuel tank b reather part No 1. Remo ve nut (2) of breather assemb ly (1) at the t op surfac el tank, then r emove cover (3) 2. Repla ce breather e lement (4) with a new 3. Instal l cover (3) an d nut (2) ening torque: 10 to 14 Nm (1.0 t o 1.4