. MAINTENANCE SERVICE PROCEDURE off all the 4. Install net (5). NOTICE 4 - 72 If compressed air cannot be u sed, use the following p rocedure 1. Remove 4 bo lts (1) at the bottom of th e rear mask 2. Pull rear mas k (2) towards you and pu Check that th e rear mask h as opened t o the maximum opening position and t hat the lock i s applied, th en release i 3. Remove 4 bo lts (4), then remove net (5) and wip mud, snow, i ce, or other m aterial stuck Triangular ribs (6) a re welded to th e corner of ne t (5) at 2 place s. Install net (5 ) so that ribs (6) a re at the positi on shown in t he diagram. 5.
Close rear m When closing the rear mas k, lift it up, s crew lock re lease knob (3) in the dire ction of the a rrow to relea se the lock , then close the rear mas 6. Tighten 4 bol ts (1) at the b ottom of the rear mask.