Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE EVERY 2000 HOURS SERVICE CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC OIL FILTER ELEMENT AND CLEAN HYDRAULIC TANK STRAINER WARNING tighten the drain valve again after draining the oil. When loosening the drain valve, be careful not to get oil over yourself. 4 - 73 Maintenance for eve ry 50, 250, 500 and 1000 hours service should be carried out at t Immediately after th e engine is stopped, the part s and the oil are at a high temperature. Wait for the temperature to go down before starting the When the cap of th e oil filler port is removed, oil may spurt out, s o turn the cap slowly to rel ease the internal pre ssure, then remove it carefully.

Refill capacity: 60 Prepare a contain Prepare a filter w Prepare a hose. 1. Lower the work equipment to the ground, t hen stop the engine. 2. Turn the cap of oil filler port (F) at the top o f the hydraulic tank slowly to releas e the internal pressure, the n remove the cap. 3. Remove 2 bolts (1), then remove cover (2) at the bottom o f the hydraulic tank. 4. Install hose (4) t o drain port (3). Use a hose that is long enough 5. to reach the con Loosen the drai tainer set in position to ca n valve of drain port (3), tch the drained drain the oil, oil. then