. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE part and install. 4 - 74 6. Open the hydraulic tank ins pection cover on the left side of the machine. Remove 4 bolts (5). Loosen both clamps of hos 7. 8. e (6) and move flange (7) towards the front of the machine tog ether with the hose. 9. Bend hose (6) towards you, remove flange (7) from the hose, then remove hose (6) from the piping. move strainer (9). 10. Remove 2 bolts (8), then re 11. Remove all dirt stuck to strai ner (9), then wash it in clean diesel oil or flushing oil. ghten with bolt (8). 12. Assemble strainer (9) and ti When doing this, replace O- ring (10) (strainer end) with a new part and install.
, then install flange (7). (5), then tighten hose (6) with the 13. 14. Install hose (6) to the piping Tighten flange (7) with bolts clamps (both sides). When doing this, replace O- ring (11) (strainer end) with a new 15. Set a container under the fil ter to catch the oil. 16. Using a filter wrench, turn hy draulic filter (return filter) cartridge 17. (12) to the left to remove it. Clean the filter holder, fill th coat the seal and thread of e new filter cartridge with oil, then the filter cartridge with oil (or coat 18. thinly with grease) and insta After the packing surface of surface of the filter holder, ti 2/3 turns. ll.
the cartridge touches the sealing ghten the cartridge further by about idge. Use Komatsu genuine cartr 19. Open the fuel tank inspect machine. ion cover on the right side of the 20. Using a filter wrench, turn c harge filter cartridge (13) to the left 21. to remove it. Clean the filter holder, fill th e new filter cartridge with oil, then coat the seal and thread of the filter cartridge with oil (or coat ll. thinly with grease) and insta 22. After the packing surface of the cartridge touches the sealing surface of the filter holder, ti 2/3 turns. ghten the cartridge further by about idge. Use Komatsu genuine cartr 23. Refill the specified quantity of oil through oil filler (F).
the oil is at the correct level. IL LEVEL IN HYDRAULIC TANK, ADD OIL (PAGE 3-74)". and cleaning or replacing filter element and strainer, bleed air from the circuit. 24. After adding oil, check that For details, see "CHECK O IL LEVEL IN HYDRAULIC TANK, 25. After replacing hydraulic oil and cleaning or replacing filter element and strainer, bleed For details of the method of bleeding the air from the hydraulic circuit, see "PROCEDUR E FOR BLEEDING AIR IN HYDRAULIC SYSTEM ( PAGE 4-45)".