MACHINE OPERATIONS AND CONTROLS OPERATION INTERFERENCE PREVENTION DEVICE (BETWEEN BUCKET AND FRONT RIGHT OUTSIDE, HANDRAIL) WARNING This device is a preventive device intended only for use in unexpected cases, so it is dangerous to rely on it completely during operations. Always be careful that the work equipment does not come close to the cab during operations.
During right offset operations, if the arm is pulled in too far, or if the arm is pulled in with the boom near the maxi- mum height, and the boom is lowered, or if the boom is at the front with the arm pulled in, and the work equipment is offset to the right, this device sounds an alarm and automatically stops the work equipment to prevent the bucket from hitting the front right outside of the bodywork and the handrail.
ACTUATION OF INTERFERENCE PREVENTION DEVICE DECELERATION RANGE AND STOP POSITION Stopping during boom LOWER If the boom is lowered with the work equipment in the posture in the diagram on the right (maximum right offset and arm pulled in fully), when the bucket enters area A (50 - 150 mm (2.0 - 5.9 in)) in the diagram on the right, the boom lowering speed will be reduced. This is to prevent the load in the bucket from being spilled when the work equipment is stopped. If the bucket continues to come close and enters area B (50 - 150 mm (2.0 - 5.9 in)) in the diagram on the right, the work equipment will automatically stop.
REMARK When there is automatic stop, operate any of the boom RAISE left offset, or arm OUT to move out of the STOP range, then continue operations. 3-94